[. . . ] The brake operates when the trigger is released and the motor stops immediately. —● Do not use other than the Panasonic battery packs that are designed for use with this rechargeable tool. Do not dispose of the battery pack in a fire, or expose it to excessive heat. Do not drive the likes of nails into the battery pack, subject it to shocks, dismantle it, or attempt to modify it. [. . . ] Clean the terminals before charging the battery pack if any foreign substances are found on the terminals. Indb 6 2013-7-24 11:03:43 The life of the battery pack terminals may be affected by foreign substances such as dust and water etc. Or battery, be sure to note the following when carrying out operation. I f the battery becomes hot, the protection function will be activated and the battery will stop operating. The battery pack is designed to be installed by proceeding two steps for safety. Make sure the battery pack is installed properly to the main unit before use. If the battery pack is not connected firmly when the switch is switched on, the main unit will not rotate normally. Connect the battery pack into the body of the tool until the red or yellow label disappears. T CAUTION:  o protect the motor ●● ●● Cool down the charger when charging more than two battery packs consecutively. Do not insert your fingers into contact hole, when holding charger or any other occasions. —● For safe use ●● To prevent the risk of fire or damage to the battery charger. —● ●● CAUTION: NOTE: Your battery pack is not fully charged at the time of purchase. Sparks may be produced when the plug is inserted into the AC power supply, but this is not a problem in terms of safety. when charging is completed , an internal electronic switch will automatically be triggered to prevent overcharging. Charging will not start if the battery pack is warm (for example, immediately after heavy-duty operation). The orange standby lamp will be flashing until the battery cools down. The charge lamp (green) will flash slowly once the battery is approximately 80% charged. When charging is completed, the charging lamp in green color will turn off. If the temperature of the battery pack is 0°C or less, charging takes longer to fully charge the battery pack than the standard charging time. Even when the battery is fully charged, it will have approximately 50% of the power of a fully charged battery at normal operating temperature. [. . . ] A replacement fuse cover can be purchased from your local Panasonic Dealer. If a new plug is to be fitted please observe the wiring code as shown below. Sørg for at sætte batteripakningsdækslet på for at beskytte batteriterminalerne. Når du oplader batteripakningen, skal du bekræfte at terminalerne på batteriopladeren er fri for uvedkommende substanser, som for eksempel støv og vand etc. [. . . ]